Set of spare parts for the Prolactis 3D SOFT electric breast pump. Daily effective support in baby care with mothers’ comfort in mind. The set includes: Silicone 3D funnel (massage insert) with check valve Silicone membrane Silicone tube with two connectors Instructions for use: Before first use, wash the parts and immerse them in cold water. Heat until boiling and then boil for 5 minutes. Remember to use enough water. During boiling, all parts must remain fully submerged. Remove all parts from the water immediately after boiling. Before assembly and use, dry all parts thoroughly. Use a clean towel for drying. Store the dried parts in a closed case or bag. You can also use a clean towel. Insufficiently dried pump parts can negatively affect the pump’s performance. Therefore, make sure all parts are thoroughly dried before use. Wash all parts by hand only in hot water with a mild detergent. Do not use strong detergents or abrasive cleaners that may scratch the surface of the parts. Rinse with clean hot water. Warning! Wash the check valve very gently and do not allow dried milk to remain in it. Always remove the check valve with two fingers by the round base. Never hold it by the tip, as you may damage it and reduce suction power. Warning! Before each use, check the condition of all parts. Cracked, hardened, discolored, or damaged parts may negatively affect the pump’s performance. The spare parts set complies with: Directive 2001/95/EC of the European Parliament and of the Council on general product safety.