The Canpol babies bottle with a capacity of 250 ml is made of high-quality polypropylene that does not contain BPA. It does not crack, is safe, lightweight, practical, and colorful. The bottle is available in three variants with an AFRICA design. It meets the highest quality standards. The standard version includes a silicone round teat with a fast flow. Replacement teats and spouts can be found in the teats and spouts section. Instructions for use: Before the first and each subsequent use, thoroughly wash and disinfect the bottle and all its parts. For hygiene reasons, boil the teat for 5 minutes in boiling water before first use. Clean before each use. After use, clean the bottle and teat from food residues, rinse, and then sterilize in a steam/electric sterilizer or in boiling water. Do not boil again! We do not recommend washing the bottle and teat in a dishwasher, as the detergents used may damage the product. Do not use any chemical antibacterial agents. Check the teat quality before each use. Pay increased attention to the teat after the child’s first teeth appear. Test the teat’s quality by stretching it thoroughly in all directions. At the first signs of damage to the teat, discard it immediately and do not use it further. Do not overtighten the screw cap, as the teat will not be able to vent properly. Check that the food does not leak from under the screw cap. Do not pierce or enlarge the holes in the teat—this may damage it. If you heat food in a microwave oven, remember that the bottle must be open. Pay increased attention when heating in the microwave. Always mix the heated food thoroughly and check its temperature before serving it to the child. Do not leave the teat near a heat source, in direct sunlight, or in disinfectants longer than recommended, as this may weaken the teat. For hygiene and safety reasons, we recommend replacing the teat after a maximum of 2 months. Warning! Important for your child’s health and safety! Use only under adult supervision. Never use a teat as a pacifier. Prolonged or extended sucking of liquids may cause damage to a child’s tooth enamel. Always check the temperature of the food being served. This product is not a toy. Keep all parts of the product out of the reach of children. The baby bottle complies with the requirements of: Regulation (EC) No 1935/2004 of the European Parliament and of the Council – general requirements for materials and articles intended to come into contact with food; Commission Regulation (EU) No 10/2011 on plastic materials and articles intended to come into contact with food; EN 14350-1 – Child care articles – Drinking equipment – Part 1: General and mechanical requirements and tests; EN 14350-2 – Child care articles – Drinking equipment – Part 2: Chemical requirements and tests.
